
Tab 1 of 12
Heat pump repair
Through the gray months we watch the defrost cycle closely, because a coil that never clears is the classic Kitsap winter call. Capacitors and the reversing valve come next.
See the service page
About Larch · Kitsap and Gig Harbor
Larch HVAC & Appliance tends the equipment that keeps peninsula homes warm, cool and fed: heat pumps, furnaces and mini-splits on one side of the house, refrigerators, ranges and laundry machines on the other. Below you'll find our background, our licenses, the rhythm of a visit and the map this site covers.
Straight to it
Larch HVAC & Appliance answers to no chain or franchise; it is a Washington company standing on its own. We fix, replace and install heat pumps, central air, air handlers, mini-splits and furnaces, and we repair fridges, ice makers, dishwashers, ranges, washers and dryers. The state licenses us as an electrical contractor with specialties 06A and 07D and as a General contractor, and refrigerant work falls to technicians carrying EPA 608 Universal.
A Washington outfit working two neighboring trades. One is comfort: repairs, seasonal tune-ups, replacements and new installs for heat pumps, ductless mini-splits, furnaces fired by gas or warmed by electric elements, air handlers and central air, along with thermostats and the low-voltage wiring behind them. The other is the kitchen and laundry room, where our technicians take apart refrigerators and freezers, ice makers, dishwashers, washers, dryers, ranges, ovens and cooktops.
Houses on this side of the water taught us what to expect. Heating runs the whole spread out here: ducted and ductless heat pumps, electric furnaces and baseboard, gas furnaces wherever a gas main reaches the street, and propane furnaces in some rural homes, where we fix the furnace and leave the tank and lines to the supplier. Plenty of households bolted on a heat pump or mini-split after the scorching June of 2021, so the equipment is often much younger than the house wrapped around it. Households rotate through Bremerton and Silverdale constantly, frequently inheriting machines with no service history at all, which is one reason our technicians write down what they measure and leave you a copy.

Two from the state and one federal credential. Washington's Department of Labor & Industries lists LARCHHA742PL as our electrical contractor license; its two specialties are 07D, covering Appliance Repair, and 06A, covering HVAC/Refrigeration. LARCHHA745PW, our General (Construction) contractor license, comes into play when an install involves building work around the equipment. Opening any sealed refrigerant circuit, whether in a chest freezer or a ducted heat pump, also requires the EPA Section 608 credential, and ours is held at the Universal level by every technician.
Those same licenses draw the edges of what we do. Our technicians test power where it reaches the equipment, and you are welcome to flip a tripped breaker back once, but panels, added circuits and gas piping are jobs for other licensed trades. When a fault traces into that territory, we tell you and jot down what we found, so the electrician or gas fitter you hire next walks in with facts. Both state records are open to anyone through the Labor & Industries Verify search.
Identically in a Haddon rambler, an Old Town Silverdale cottage or a Canterwood two-story. The office calls to pin down your date and arrival window, the technician rings once rolling, and the diagnosis starts with instruments rather than hunches: microfarads on a capacitor, amp draw on a blower motor, superheat and subcooling on the sealed system, microamps through a flame sensor, continuity across a thermal fuse. A written repair price follows, and nothing gets swapped until you nod.
Our fee rule travels unchanged from Bremerton to Fox Island. A diagnostic visit carries a fee, and the office quotes its amount at the time you schedule. If the repair proceeds, that fee merges into its price; if not, that fee is the full charge for our time. New systems get one written figure combining equipment and installation, everyday wear parts ride on the truck, special-order parts carry a price you see before any order goes in, and every invoice states its warranty terms in writing.
Each tab holds a photo from our service calls and a note on what we check first. Pick any tab; left alone, they turn every few seconds.

Tab 1 of 12
Through the gray months we watch the defrost cycle closely, because a coil that never clears is the classic Kitsap winter call. Capacitors and the reversing valve come next.
See the service page
Tab 2 of 12
More Kitsap homes have cooling since the 2021 heat dome. When a system falls behind on a hot afternoon, we start with airflow, the capacitor and the refrigerant charge.
See the service page
Tab 3 of 12
Many older Bremerton and Manette houses keep the furnace in a closet or under the floor. Filter, inducer, flame sensor and limit switch all get checked in that tight space.
See the service page
Tab 4 of 12
Placement matters on the peninsula: a raised pad clear of wet ground, back from salt spray where the lot allows, and out from under the needle drop.
See the service page
Tab 5 of 12
Mini-splits fit older homes with no room for ducts. Their line sets need sound insulation where they cross a damp crawlspace, and the outdoor unit needs a clear drain path.
See the service page
Tab 6 of 12
A seasonal visit near the water means a coil rinse, a look at the fasteners for salt rust and a base pan that drains. Those three buy waterfront equipment years.
See the service page
Tab 7 of 12
Sealed-system work, from leak search to recharge, happens right in the kitchen under EPA 608 Universal credentials, so the fridge stays where it stands.
See the service page
Tab 8 of 12
Damp Kitsap laundry rooms are hard on door boots, so mildew, torn folds and a clogged pump filter are the first things we look at on a front-loader.
See the service page
Tab 9 of 12
Long vent runs through damp walls fill with lint quickly, so the vent gets tested along with the heating side: element or burner, thermal fuse and thermostats.
See the service page
Tab 10 of 12
Well water leaves minerals on the spray arms and the inlet screen, two early stops when dishes come out dull or the tub fills slowly.
See the service page
Tab 11 of 12
Natural gas and propane ranges both get igniter, valve and flame checks. The tank and its lines stay with your propane supplier.
See the service page
Tab 12 of 12
After a windstorm outage the fill tube often freezes solid and the ice maker goes quiet, so we follow the water up from the inlet valve.
See the service pageFive communities: Bremerton, split by the Port Washington Narrows, with Sinclair Inlet along its southeast edge; Silverdale, the unincorporated town at the north tip of Dyes Inlet; Poulsbo, the Liberty Bay town Norwegian settlers founded in the 1880s and still called Little Norway; Gig Harbor in Pierce County, with Canterwood, Purdy, Rosedale, Artondale and Wollochet nearby; and Fox Island, reached only by its bridge over Hale Passage.
Larch also runs services-wa.com for Spokane and hvac0.com for the north end of the Puget Sound metro, and serves the South Sound and Washington's southeast. Each region keeps a separate site since rainfall, housing stock and travel routes vary from one to the next, yet the licenses, the price-in-writing habit and the invoice warranty stay identical. For an address on this side of the water, pick the date you want on this site's booking page, then the arrival window, or phone the office, which opens at 8 AM and closes at 7 PM daily.
Neither. No franchisor or parent brand sits above Larch HVAC & Appliance; the state issues its licenses directly to this Washington business. The Spokane site and the one for the north end of the metro belong to that same company. Dial the number on this page and you reach the office that schedules Larch technicians, and the person ringing your doorbell is covered by the licenses on this page.
Yes. Every one holds the EPA 608 credential at the Universal level, which spans small appliances like fridges and freezers plus the high-pressure and low-pressure systems found in heat pumps and central air. So the same person can hunt down a leak, recover the remaining charge into a cylinder, repair the joint, pull a vacuum and weigh refrigerant back in, with no second contractor needed.
Yes. Heat pumps, furnaces, air handlers, central air and ductless mini-splits are all equipment we replace and install, duct connections at the equipment included, under the 06A specialty with our General contractor license behind the building side. You receive one written number that bundles the equipment with the installation. If the job also needs new electrical service or gas piping, the quote names that piece so the right trade can handle it.
Talk to a person
Choose your date online, tack on an arrival window, and expect the office to ring and lock it in. Questions about who we are? The line is staffed daily between 8 AM and 7 PM.
Schedule online
Tell us what needs attention, the day that works and the window you prefer. A scheduler calls to make it firm, and the technician rings again before pulling up.
Washington Labor & Industries keeps these records public. Each number can be searched on L&I Verify; scope details sit on a separate page.
Scope of each license