
Tab 1 of 12
Heat pump repair
Through the gray months we watch the defrost cycle closely, because a coil that never clears is the classic Kitsap winter call. Capacitors and the reversing valve come next.
See the service page
Licenses and scope
Anyone about to open your furnace cabinet or braze into a refrigerant line should be able to show what they're licensed for. Here is every license and credential Larch carries, a quick way to confirm them on the state's own lookup, and the categories of work we send elsewhere.
Straight to it
Larch holds Washington electrical contractor license LARCHHA742PL, whose two specialties are 07D for appliance repair and 06A for HVAC and refrigeration, along with General contractor license LARCHHA745PW. Each technician carries the federal EPA 608 credential at the Universal level. Both state records appear on Labor & Industries Verify. Breaker panels, added circuits, gas piping, household water lines, oil and propane tanks, and boat refrigeration all fall outside our scope.
EPA
Held by the technicians who handle refrigerant
Each one covers a separate slice of the job, and all of it applies statewide, from East Bremerton across to Fox Island.
Run either number through Verify, the public contractor search on the Washington Department of Labor & Industries website. It takes about a minute, and the steps are simple:
Anything that feeds the equipment from the house side, and anything carrying the household's water. We would rather flag that on the written quote than discover it with tools already out.
Our technicians check the voltage reaching each piece of equipment at its own terminals, and you may check or reset a tripped breaker once on your own. Peninsula housing makes this practical: an early 20th-century home on the west side or in Manette can need an electrician to upgrade the service before any new heat pump arrives, and a rural Poulsbo or Gig Harbor home on propane depends on its supplier for the tank and lines, while we repair the furnace or range that burns the fuel. Outside our work:
Each tab holds a photo from our service calls and a note on what we check first. Pick any tab; left alone, they turn every few seconds.

Tab 1 of 12
Through the gray months we watch the defrost cycle closely, because a coil that never clears is the classic Kitsap winter call. Capacitors and the reversing valve come next.
See the service page
Tab 2 of 12
More Kitsap homes have cooling since the 2021 heat dome. When a system falls behind on a hot afternoon, we start with airflow, the capacitor and the refrigerant charge.
See the service page
Tab 3 of 12
Many older Bremerton and Manette houses keep the furnace in a closet or under the floor. Filter, inducer, flame sensor and limit switch all get checked in that tight space.
See the service page
Tab 4 of 12
Placement matters on the peninsula: a raised pad clear of wet ground, back from salt spray where the lot allows, and out from under the needle drop.
See the service page
Tab 5 of 12
Mini-splits fit older homes with no room for ducts. Their line sets need sound insulation where they cross a damp crawlspace, and the outdoor unit needs a clear drain path.
See the service page
Tab 6 of 12
A seasonal visit near the water means a coil rinse, a look at the fasteners for salt rust and a base pan that drains. Those three buy waterfront equipment years.
See the service page
Tab 7 of 12
Sealed-system work, from leak search to recharge, happens right in the kitchen under EPA 608 Universal credentials, so the fridge stays where it stands.
See the service page
Tab 8 of 12
Damp Kitsap laundry rooms are hard on door boots, so mildew, torn folds and a clogged pump filter are the first things we look at on a front-loader.
See the service page
Tab 9 of 12
Long vent runs through damp walls fill with lint quickly, so the vent gets tested along with the heating side: element or burner, thermal fuse and thermostats.
See the service page
Tab 10 of 12
Well water leaves minerals on the spray arms and the inlet screen, two early stops when dishes come out dull or the tub fills slowly.
See the service page
Tab 11 of 12
Natural gas and propane ranges both get igniter, valve and flame checks. The tank and its lines stay with your propane supplier.
See the service page
Tab 12 of 12
After a windstorm outage the fill tube often freezes solid and the ice maker goes quiet, so we follow the water up from the inlet valve.
See the service pageIt means the technician may legally open a sealed refrigerant circuit, which federal rules restrict, and must capture the refrigerant rather than let it escape. Universal is the widest tier: it reaches the small sealed systems in refrigerators and freezers, high-pressure gear such as heat pumps and air conditioners, and low-pressure machines too.
Out here it comes up constantly. Plenty of homes that never had air conditioning added a heat pump or mini-split once Bremerton hit 110°F in June 2021, and every one of those systems holds a refrigerant charge. Salt spray near Sinclair Inlet, Liberty Bay and Hale Passage can also eat a coil down to pinhole leaks. When our technician finds a short charge, the work follows a fixed order: find the leak, by electronic sniffer or soap bubbles, recover what remains into a cylinder, repair, pressure-test with nitrogen, pull a vacuum measured in microns, weigh the charge back in, and confirm it against superheat and subcooling. To set that in motion, book online or give the office a call.
Washington counts the electrical side of heating, cooling and appliance repair as electrical work, so the company doing it needs an electrical contractor license carrying the matching specialty. Ours, LARCHHA742PL, lists 06A for HVAC and refrigeration and 07D for appliances. LARCHHA745PW, a General contractor license, handles the building portion of installs. Both can be looked up on L&I Verify.
No. Bringing a fresh power feed to the equipment or adding a breaker is electrician's work, and our licenses don't include it. If your new mini-split or heat pump needs a supply that isn't there yet, our written quote flags it, and our installation is booked after the electrician is done. Our technicians do measure voltage at the equipment, and you can reset a tripped breaker once.
No to both. Refrigeration on a boat falls outside our licenses even when the boat is tied up below the house, and propane tanks, regulators and supply lines belong to your propane supplier. What we can handle is the household refrigerator, freezer or ice maker, and the propane furnace, range or dryer inside the home, under our 06A and 07D specialties.
Talk to a person
Look up both numbers on Verify. Then go online to request a date, along with an arrival window, or phone; the office opens at 8 AM and takes calls until 7 PM, all week.
Schedule online
Tell us what needs attention, the day that works and the window you prefer. A scheduler calls to make it firm, and the technician rings again before pulling up.
Washington Labor & Industries keeps these records public. Each number can be searched on L&I Verify; scope details sit on a separate page.
Scope of each license