Jump to main content
Bremerton · Silverdale · Poulsbo · Gig Harbor · Fox IslandLive answer daily, 8 AM until 7 PM
LarchHVAC & Appliance (360) 728-3833
Technician at a dryer repair in a small laundry room

Contact

Two ways to reach Larch: phone the office or book online

Pick up the phone or fill in the booking page; either path ends with the office ringing you to settle the time. Below is how each one works, plus a short list of details that let the technician load the likely parts and find your driveway without a detour.

What are the ways to reach us?

By phone or online. The office line has a person on it daily, opening at 8 AM and closing at 7 PM. Whoever answers will listen to what the heat pump, furnace or appliance is doing, quote the diagnostic fee and look for an open slot. Online booking runs around the clock: choose the date that suits you, add an arrival window, jot a line or two about the problem and submit.

Whichever door you use, the office follows up with a confirming call, so keep the phone nearby. On the day itself, the technician rings as the truck heads your way. We cover Bremerton, Silverdale, Poulsbo, Gig Harbor and Fox Island; if you're not sure your road falls inside that map, ask during the call and the office can tell you on the spot.

One exception to all of this: if anyone smells gas or propane, skip the booking page and the phone call to us. Get everyone outdoors, and only from a safe distance dial 911 or whoever supplies your gas or propane.

What helps to have on hand when you get in touch?

None of these are required, but each one trims time at your door and helps the right parts make the trip:

  • Model and serial numbers from the rating tag. Outdoor heat pumps and AC condensers carry it on a side panel; furnaces and air handlers keep it inside the blower door; refrigerators usually hide it somewhere inside the main compartment, high on a liner wall; dishwashers on the door's edge or tub rim; washers and dryers beneath the lid, near the door seal or across the rear panel.
  • What the equipment is doing, in your own words: odd noises, smells, leaks, what quit working and about how long ago.
  • Fault codes, flashing lights or a thermostat message. A phone photo of a furnace board's status light or a range display saves guesswork.
  • Steps you've already taken, such as swapping the filter, putting fresh batteries in the thermostat or resetting a breaker once.
  • Where the equipment lives: crawlspace hatch, attic, garage, hall closet, or a mini-split head high on a bedroom wall.
  • Access notes: a gate code, a shared private road, parking on a steep waterfront lot, pets in the yard, or directions to an island driveway on Fox Island.
  • In Bremerton, whether you're east or west of the Port Washington Narrows, since the route changes with the bridge.
  • If you rent, the landlord's or property manager's name, so the person who signs off on repairs sees the written price.

Twelve tabs, one for each kind of job

Each tab holds a photo from our service calls and a note on what we check first. Pick any tab; left alone, they turn every few seconds.

Heat pump outdoor unit with a digital gauge set during a refrigerant charge

Tab 1 of 12

Heat pump repair

Through the gray months we watch the defrost cycle closely, because a coil that never clears is the classic Kitsap winter call. Capacitors and the reversing valve come next.

See the service page
1 / 12

Talk to a person

Ready for a visit?

Use online booking to ask for a date and an arrival window, then wait for the office's confirming call, or phone during staffed hours, which start at 8 AM and run until 7 PM every day.

Schedule online

Three screens, then a confirming call

Tell us what needs attention, the day that works and the window you prefer. A scheduler calls to make it firm, and the technician rings again before pulling up.

  • Diagnostic named on the call, credited toward any repair you okay.
  • Common wear parts ride along, which often means one trip does it. Anything we must order is quoted to you first.
  • Bridges and islands are fine: add directions or gate notes in the problem box.

(360) 728-3833

Schedule a service visit

Pick the equipment, a day and a window. A scheduler calls to confirm before anything is final.

What needs a look
Day & details
Which day
Arrival window
Contact

The diagnostic charge is stated when we call and credited toward any repair you approve. We use these details only to set up the visit.

State licenses you can look up

Washington Labor & Industries keeps these records public. Each number can be searched on L&I Verify; scope details sit on a separate page.

Scope of each license
CallSchedule